This resin delivered great results, even on my older printer. The prints came out sharp and detailed, easily the best quality I’ve gotten from my setup so far. The cured resin has a little give to it, not rubbery, but just enough to keep small parts from snapping too easily.
While removing supports from a dragon model, one of the wings broke slightly due to the angle I pulled at. What impressed me was that it didn’t shatter or fully snap off. The break held together well enough that I could repair it easily, and the joint stayed flexible afterward. With more brittle resin, I’m pretty sure the wing would’ve snapped clean off and been hard to fix.
The gray color makes a great base for painting, and the prints were consistent with no visible warping or shrinking. Support removal was smooth on most models, with minimal cleanup.